Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PANORAMIC VIEW MONITOR SYSTEM › from 2021.02
RM33C0E _56 Audio / Visual / Telematics _065452 PARK ASSIST / MONITORING _0468732 PANORAMIC VIEW MONITOR SYSTEM C

PARK ASSIST / MONITORING  PANORAMIC VIEW MONITOR SYSTEM  C1691  Back Camera Initialization Incomplete  


DESCRIPTION

This DTC is stored when the rear television camera assembly judges that the back camera initial setting has not been memorized (rear television camera assembly optical axis adjustment (back camera position setting) is incomplete).

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
C1691 Back Camera Initialization Incomplete Back camera initial setting has not been memorized (rear television camera assembly optical axis adjustment (back camera position setting) is incomplete)
·

Rear television camera assembly optical axis adjustment (back camera position setting)

·

Rear television camera assembly


Rear Camera

CAUTION / NOTICE / HINT

NOTICE:
·

When "!" is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>INITIALIZATION

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION



PROCEDURE

1.PERFORM SETTINGS (BACK CAMERA POSITION SETTING)
a.

Perform the following procedure depending on the memory conditions to register the vehicle information into the rear television camera assembly.

i.

Rear television camera assembly optical axis adjustment (back camera position setting).

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION



Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Clear the DTCs.

Chassis > Rear Camera > Clear DTCs
50002 85

b.

Recheck for DTCs and check that no DTCs are output.

Chassis > Rear Camera > Trouble Codes
50001 85
HINT:
·

If DTC C1691 is output, perform the rear television camera assembly optical axis adjustment (back camera position setting) again.

·

If DTC C1691 is still output after performing the rear television camera assembly optical axis adjustment 3 times, replace the rear television camera assembly.




Result:
Result Proceed to
DTC C1691 is output A
DTC C1691 is not output B



A

B

END