Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PANORAMIC VIEW MONITOR SYSTEM › from 2021.02
RM33C0E _56 Audio / Visual / Telematics _065452 PARK ASSIST / MONITORING _0468732 PANORAMIC VIEW MONITOR SYSTEM C

PARK ASSIST / MONITORING  PANORAMIC VIEW MONITOR SYSTEM  C1626  Steering Angle Sensor Failure  


DESCRIPTION

This DTC is stored if the television camera controller and rear television camera assembly receives a signal via CAN communication from the steering sensor that indicates an internal malfunction.

Television Camera Controller
DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
C1626 Steering Angle Sensor Failure A fail flag is transmitted from the steering angle sensor
·

Steering sensor

·

Television camera controller


Circumference Monitoring Camera Control Module

Rear Television Camera Assembly
DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
C1626 Steering Angle Sensor Failure A fail flag is transmitted from the steering angle sensor
·

Steering sensor

·

Rear television camera assembly


Rear Camera

CAUTION / NOTICE / HINT

NOTICE:
·

When "!" is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>INITIALIZATION

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION

·

The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION



PROCEDURE

1.CHECK DTC OUTPUT
a.

Clear the DTCs.

Chassis > Circumference Monitoring Camera Control Module > Clear DTCs
50002 353
Chassis > Rear Camera > Clear DTCs
50002 85

b.

Recheck for DTCs and check that no DTCs are output.

Chassis > Circumference Monitoring Camera Control Module > Trouble Codes
50001 353
Chassis > Rear Camera > Trouble Codes
50001 85

Result:
Result Proceed to
DTC C1626 is output A
DTC C1626 is not output B



A

2.REPLACE STEERING SENSOR

B

2.REPLACE STEERING SENSOR
a.

Replace the steering sensor with a new or known good one.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>STEERING ANGLE SENSOR>REMOVAL


Result:
Proceed to
NEXT



NEXT

3.CHECK DTC OUTPUT
3.CHECK DTC OUTPUT
a.

Clear the DTCs.

Chassis > Circumference Monitoring Camera Control Module > Clear DTCs
50002 353
Chassis > Rear Camera > Clear DTCs
50002 85

b.

Check for DTCs.

Chassis > Circumference Monitoring Camera Control Module > Trouble Codes
50001 353
Chassis > Rear Camera > Trouble Codes
50001 85

Result:
Result Proceed to
No DTCs are output A
DTC C1626 is output ("Panoramic View Monitor") B
DTC C1626 is output ("Parking Assist Camera") C



A

END (STEERING SENSOR WAS DEFECTIVE)

B

C