The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during mobilephone battery removal/installation are shown below.
Risk of explosion if the battery is replaced by an incorrect type. Replace battery with the same type.
Risk of explosion or the leakage of flammable liquid or gas.
Do not use in /store in /bring into environment of extremely high temperature or extremely low pressure due to the very high altitude.
Do not attempt to burn, crush, or cut used battery.
1. PRECAUTION
2.REMOVE TELEMATICS TRANSCEIVER WITH BRACKET
86725
3.REMOVE MOBILEPHONE BATTERY
Disengage the 4 claws to remove the transceiver cover.
|
Remove in this Direction |
Disconnect the connector.
Remove the mobilephone battery as shown in the illustration.