Home › Suspension › FRONT SUSPENSION › FRONT LOWER SUSPENSION ARM › from 2021.02
RM33C0E _53 Suspension _065438 FRONT SUSPENSION _0334229 FRONT LOWER SUSPENSION ARM A

FRONT SUSPENSION  FRONT LOWER SUSPENSION ARM  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front lower No. 1 suspension arm sub-assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front wheel alignment adjustment
1.

Clear zero point calibration data.

2.

Perform yaw rate and acceleration sensor zero point calibration.


·

DTCs are stored

·

ABS warning light illuminates

·

Brake warning light / yellow (minor malfunction) illuminates

·

Slip indicator light illuminates

·

VSC disabled or malfunctions


(Click here)
Suspension, tires, etc.
(The vehicle height changes because of suspension or tire replacement)
·

Measure ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking Support Brake System (Click here)
Rear television camera assembly optical axis (Back camera position setting) Parking Assist Monitor System (Click here)
Perform headlight ECU sub-assembly LH initialization Lighting System (EXT) (w/ Automatic Headlight Beam Level Control System) (Click here)
·

Television camera controller initialization

·

Adjust steering angle

·

Rear television camera assembly optical axis (Back camera position setting)


Panoramic View Monitor System (Click here)for Initialization
(Click here)for Calibration

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 53851M 2.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH (w/ Cover)

Hide 53852K 3.REMOVE FRONT WHEEL OPENING EXTENSION PAD LH (w/ Cover)

Hide 51441 4.REMOVE NO. 1 ENGINE UNDER COVER (w/ Cover)

Hide 51442 5.REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY (w/ Cover)

Hide 58166A 6.REMOVE FRONT FLOOR COVER LH (w/ Cover)

Hide 53737B 7.REMOVE FRONT FENDER APRON SEAL LH

Hide 48069 8.REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY

a.
C370077

Remove the bolt and 2 nuts and separate the front lower No. 1 suspension arm sub-assembly from the front lower ball joint assembly.


b.
C370078

Remove the 3 bolts, nut and front lower No. 1 suspension arm sub-assembly from the front frame assembly.

NOTICE:

Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.



c.

Remove the front lower arm bushing stopper from the front lower No. 1 suspension arm sub-assembly.