Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER CONTROL RELAY › from 2021.02
RM33C0E _59 Vehicle Exterior _065471 WIPER / WASHER _0332916 HEADLIGHT CLEANER CONTROL RELAY A

WIPER / WASHER  HEADLIGHT CLEANER CONTROL RELAY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during headlight cleaner control relay removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link

*1: Applies only for when removing and installing or replacing the rear television camera assembly.

Front bumper assembly (w/ Panoramic View Monitor System)
·

Measure ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking Support Brake System (Click here)
Front bumper assembly (w/ Panoramic View Monitor System) Front television camera view adjustment Panoramic View Monitor System (Click here)for Initialization
(Click here)for Calibration
Replacement or removal and installation of 2 or more parts:
·

Front television camera assembly, front bumper assembly or radiator grille

·

Rear television camera assembly

·

Side television camera assembly LH or outer rear view mirror assembly LH

·

Side television camera assembly RH or outer rear view mirror assembly RH


·

Television camera view adjustment

·

Rear television camera assembly optical axis (Back camera position setting)*1



PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 85942 2.REMOVE HEADLIGHT CLEANER CONTROL RELAY

a.
E379217C01
0,0 0,0 false
V113147

Remove in this Direction


Disconnect the connector.


b.

Disengage the claw and remove the headlight cleaner control relay as shown in the illustration.