When an injector assembly is replaced, the injector's compensation code must be input into the ECM (Proceed to step 1).
When the ECM is changed, all of the existing injector compensation codes must be input into the new ECM (Proceed to step 2).
1. INPUT INJECTOR COMPENSATION CODE(S) INTO ECM
Injector compensation codes are unique, 30-digit, alphanumeric values printed on the head portion of each injector assembly. If an incorrect injector compensation code is input into the ECM, the engine may rattle or engine idling may become rough. In addition, an engine failure may occur and the life of the engine may be shortened.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
| *a | Example |
| *b | Injector Compensation Code |
Do not start the engine.
The injector compensation code is printed on the head portion of each injector assembly.
Enter the following menus: Powertrain / Engine and ECT / Utility / Injector Compensation.
Press "Next".
Press "Next" again to proceed.
Select "Set Compensation Code".
Press "Next".
Select the number of the cylinder corresponding to the injector compensation code that you want to register.
Press "Next".
Register the compensation code.
Press "Input".
Manually input the cylinder's compensation code using the keyboard on the GTS screen. The code is a 30-digit, alphanumeric value printed on the injector's head portion.
Each injector compensation code is unique. The correct compensation code must be input into each cylinder selected on the GTS.
Confirm that the compensation code is correct for the selected cylinder, and then press "OK".
Check that the compensation code displayed on the screen is correct, by comparing it with the 30-digit alphanumeric value on the head portion of the injector assembly.
If an incorrect injector compensation code was input into the ECM, the engine may rattle or engine idling may become rough. In addition, an engine failure may occur and the life of the engine may be shortened.
If a wrong compensation code was input or read, return to the "Input Value" screen by pressing "Input".
The saving process may fail due to a problem with the wire harness or a bad connection with the DLC3. Check the wire harness and the DLC3 connection. If no problem is found, the ECM may be malfunctioning. Check the ECM and repeat this operation.
Press "Next" to resister the compensation code in the ECM.
If the setting process fails, the compensation code may be incorrect. Check the compensation code again.
If the attempted compensation code is correct, a problem with the wire harness or a bad connection with the DLC3 might cause the failure. Check the wire harness and the DLC3 connection. If no problem is found, the ECM may be malfunctioning. Check the ECM and repeat this operation.
To continue with compensation code registrations for other cylinders, press "Next". To finish the registration, press "Exit".
Turn the ignition switch off and then turn the GTS off.
Wait for at least 30 seconds.
Turn the ignition switch to ON and then turn the GTS on.
Clear DTC P062F stored in the ECM using the GTS (Click hereEngine / Hybrid System>N04C-VQ (ENGINE CONTROL)>ECD SYSTEM>DTC CHECK / CLEAR).
2. READ VIN
Confirm the vehicle VIN
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Utility / VIN / VIN Read.
According to the display on the GTS, read the VIN stored in the ECM.
3. WRITE VIN
Confirm the vehicle VIN
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Utility / VIN / VIN Read.
According to the display on the GTS, write the VIN stored in the ECM.