Home › Engine / Hybrid System › N04C-VQ (ENGINE CONTROL) › INTAKE AIR TEMPERATURE SENSOR
RM2850E _51 Engine / Hybrid System _073138 N04C-VQ ENGINE CONTROL _0355861 INTAKE AIR TEMPERATURE SENSOR A

N04C-VQ ENGINE CONTROL  INTAKE AIR TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89424G 1.INSTALL INTAKE AIR TEMPERATURE SENSOR

a.

Install a new gasket to the intake air temperature sensor.


b.
A329093E06
1.759,0.583 1.944,0.738 0.185,0.155 10 *a

Using a union nut wrench, install the intake air temperature sensor.

Torque:
Specified tightening torque:

20 N*m (200 kgf*cm, 14 ft.*lbf)


Text in Illustration
*a Torque Wrench Fulcrum Length

NOTICE:

Do not damage the intake air temperature sensor.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench (See page ).

·

When using a union nut wrench (fulcrum length of 25 mm (0.984 in.)) + torque wrench (fulcrum length of 180 mm (7.087 in.)): 18 N*m (179 kgf*cm, 13 ft.*lbf)




c.

Connect the 2 clamps.


d.

Connect the wire harness bracket with the bolt.

Torque:

29 N*m (291 kgf*cm, 21 ft.*lbf)



e.

Connect the intake air temperature sensor connector.


Hide 44379A 2.INSTALL NO. 2 OIL RESERVOIR BRACKET

Hide 44360 3.CONNECT VANE PUMP OIL RESERVOIR ASSEMBLY

Hide 58701A 4.INSTALL FRONT ENGINE SERVICE COVER PANEL SUB-ASSEMBLY

Hide 33506F 5.INSTALL FLOOR SHIFT CONTROL SHIFT LEVER RETAINER SUB-ASSEMBLY

Hide 58123A 6.INSTALL SHIFT AND SELECT LEVER SUPPORT WITH BOOTS

Hide 58420 7.INSTALL NO. 2 ENGINE SERVICE HOLE COVER ASSEMBLY

Hide 58734B 8.INSTALL REAR ENGINE SERVICE COVER WEATHERSTRIP

Hide 58410 9.INSTALL ENGINE SERVICE HOLE COVER

Hide 58521D 10.INSTALL ENGINE SERVICE HOLE COVER MAT