84540
1.INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
Install the park/neutral position switch to the automatic transmission.
Temporarily install the 2 bolts.
Install a new lock washer and the nut.
7.0 N*m (71 kgf*cm, 62 in.*lbf)
Using a screwdriver, bend the tabs of the lock washer.
Temporarily install the transmission control shaft lever LH.
Turn the control shaft lever clockwise until it stops, and turn it counterclockwise 2 notches to set it to the N position.
Remove the transmission control shaft lever LH.
Align the neutral alignment mark line with the switch groove, and tighten the adjusting bolt.
13 N*m (133 kgf*cm, 10 ft.*lbf)
35573
2.INSTALL TRANSMISSION CONTROL SHAFT LEVER LH
Install the transmission control shaft lever LH with the 2 nuts.
13 N*m (133 kgf*cm, 10 ft.*lbf)
Connect the park/neutral position switch connector.
33820B
3.INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
Install the transmission control cable assembly with the nut and a new clip.
14 N*m (143 kgf*cm, 10 ft.*lbf)
4.CONNECT CABLE TO NEGATIVE TERMINAL
3.9 N*m (40 kgf*cm, 35 in.*lbf)
5.ADJUST TRANSMISSION FLOOR SHIFT ASSEMBLY
6.INSPECT SHIFT LEVER POSITION
84540
7.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY