31410
1.INSTALL CLUTCH MASTER CYLINDER ASSEMBLY
w/o Clutch Booster:
Install the clutch master cylinder assembly to the pedal bracket sub-assembly with the 2 bolts.
17 N*m (175 kgf*cm, 13 ft.*lbf)
Apply MP grease to the clutch master cylinder push rod clevis with hole pin.
|
MP grease |
Install the clutch master cylinder push rod clevis with hole pin with a new clip as shown in the illustration.
| *a | OK |
| *b | NG |
w/ Clutch Booster:
Install the clutch master cylinder assembly to the clutch booster assembly (w/ air cleaner) with the 2 nuts.
13 N*m (130 kgf*cm, 9 ft.*lbf)
31481K
2.CONNECT MASTER CYLINDER TO TUBE CONNECTOR TUBE
w/o Clutch Booster:
Using a union nut wrench (12 mm), connect the master cylinder to tube connector tube to the clutch master cylinder assembly.
24 N*m (245 kgf*cm, 18 ft.*lbf)
| *a | Torque Wrench Fulcrum Length |
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 20 mm (0.787 in.)) + torque wrench (fulcrum length of 180 mm (7.087 in.)): 22 N*m (220 kgf*cm, 16 ft.*lbf)
w/ Clutch Booster:
Using a union nut wrench (12 mm), connect the master cylinder to tube connector tube to the clutch master cylinder assembly.
24 N*m (245 kgf*cm, 18 ft.*lbf)
| *a | Torque Wrench Fulcrum Length |
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 20 mm (0.787 in.)) + torque wrench (fulcrum length of 180 mm (7.087 in.)): 22 N*m (220 kgf*cm, 16 ft.*lbf)
31434
3.CONNECT CLUTCH RESERVOIR TUBE
Connect the clutch reservoir tube to the clutch master cylinder assembly and slide the clamp to secure the tube.
4.CHECK FOR CLUTCH FLUID LEAKAGE
5.BLEED AIR FROM CLUTCH PIPE LINE
6.CHECK FLUID LEVEL IN RESERVOIR
55301
7.INSTALL INSTRUMENT PANEL SUB-ASSEMBLY