Home › Engine / Hybrid System › N04C-VQ (FUEL) › COMMON RAIL
RM2850E _51 Engine / Hybrid System _073145 N04C-VQ FUEL _0355920 COMMON RAIL A

N04C-VQ FUEL  COMMON RAIL  REMOVAL  


PROCEDURE

Hide 1.SET NO. 1 CYLINDER TO TDC / COMPRESSION

Hide 25608 2.REMOVE EGR COOLER SUB-ASSEMBLY

Hide 3.DISCONNECT WIRE HARNESS AND CONNECTORS

a.
A260328

Disconnect the 2 connectors and clamp.


Hide 23741B 4.REMOVE INJECTION PIPE CLAMP

a.
A257835

Remove the 2 bolts and 2 injection fuel pipe clamps.


Hide 23811 5.DISCONNECT FUEL FILTER TO INJECTION PUMP FUEL PIPE

a.
A257606

Remove the 2 nuts and 2 fuel pipe clamps.


b.

Using a 17 mm union nut wrench, loosen the union nut.


c.

Disconnect the fuel filter to injection pump fuel pipe.

NOTICE:

Be sure to prevent foreign matter or water from entering the lines.



Hide 6.REMOVE INJECTION PIPE

a.
A257605

Using a 17 mm union nut wrench, loosen the 8 union nuts and remove the injection pipe sub-assembly.

NOTICE:

Be sure to prevent foreign matter or water from entering the lines.



Hide 23810A 7.REMOVE COMMON RAIL ASSEMBLY

a.
A256519

Disconnect the fuel pressure sensor connector as shown in the illustration.


b.
A257603

Remove the union bolt and disconnect the fuel pipe.


c.
A260330

Remove the 2 bolts, fuel support and common rail assembly.