Home › Engine / Hybrid System › N04C-VQ (FUEL) › COMMON RAIL
RM2850E _51 Engine / Hybrid System _073145 N04C-VQ FUEL _0355920 COMMON RAIL A

N04C-VQ FUEL  COMMON RAIL  INSTALLATION  


PROCEDURE

Hide 23810A 1.INSTALL COMMON RAIL ASSEMBLY

a.

Install the common rail assembly and fuel support with the 2 bolts.

Torque:

55 N*m (560 kgf*cm, 41 ft.*lbf)



b.

Connect the fuel pipe and new gasket with the union bolt.

Torque:

20 N*m (200 kgf*cm, 15 ft.*lbf)



c.

Connect the fuel pressure sensor connector.


Hide 2.INSTALL INJECTION PIPE SUB-ASSEMBLY

a.

Temporarily install the injection pipe sub-assembly with the 8 union nuts.


b.

Using a 17 mm union nut wrench, tighten the 8 union nuts.

Torque:
Specified tightening torque:

35 N*m (357 kgf*cm, 26 ft.*lbf)


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

·
A329093E12
1.688,0.604 2,0.802 0.313,0.198 10 false *a

When using a union nut wrench (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 30 N*m (306 kgf*cm, 22 ft.*lbf)

Text in Illustration
*a Torque Wrench Fulcrum Length




Hide 23811 3.CONNECT FUEL FILTER TO INJECTION PUMP FUEL PIPE

a.

Using a 17 mm union nut wrench, connect the fuel filter to injection pump fuel pipe with the union nut.

Torque:
Specified tightening torque:

35 N*m (357 kgf*cm, 26 ft.*lbf)


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

·
A329093E12
1.688,0.604 2,0.802 0.313,0.198 10 false *a

When using a union nut wrench (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 30 N*m (306 kgf*cm, 22 ft.*lbf)

Text in Illustration
*a Torque Wrench Fulcrum Length




b.

Install the 2 fuel pipe clamps with the 2 nuts.

HINT:

Tighten the nut until the clamp edge makes contact with the engine side clamp edge.



Hide 23741B 4.INSTALL INJECTION PIPE CLAMP

a.

Install the 2 injection pipe clamps with the 2 bolts.

Torque:

29 N*m (291 kgf*cm, 21 ft.*lbf)



Hide 5.INSTALL WIRE HARNESS AND CONNECTORS

a.

Connect the 2 connectors and clamp.


Hide 25608 6.INSTALL EGR COOLER SUB-ASSEMBLY

Hide 8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL