Home › Engine / Hybrid System › 1HZ (ENGINE MECHANICAL) › COMPRESSION CHECK
RM2850E _51 Engine / Hybrid System _073150 1HZ ENGINE MECHANICAL _0355943 COMPRESSION CHECK A

1HZ ENGINE MECHANICAL  COMPRESSION CHECK  CHECK  


CAUTION / NOTICE / HINT

HINT:

If there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure.


PROCEDURE

Hide 1.WARM UP AND STOP ENGINE

a.

Allow the engine to reach normal operating temperature.


Hide 2.DISCONNECT INJECTION PUMP (FUEL CUT SOLENOID) CONNECTOR

Hide 4.CHECK CYLINDER COMPRESSION PRESSURE

a.
A422373

Install SST (attachment) to the glow plug hole.


b.
A422374

Connect SST (compression gauge) to SST (attachment).


c.

Fully open the throttle valve.


d.

While cranking the engine, measure the compression pressure.

HINT:

Always use a fully charged battery to obtain engine revolution of 250 rpm or more.



e.

Repeat steps (a) through (d) for each cylinder.

NOTICE:

This measurement must be done in as short a time as possible.


Compression pressure:
1PZ and 1HZ:

37.0 kg/cm2 (526 psi, 3,628 kPa) or more

1HD-T:

35.0 kg/cm2 (498 psi, 3,432 kPa) or more


Minimum pressure:
1PZ and 1HZ:

27.0 kg/cm2 (384 psi, 2,648 kPa) or more

1HD-T:

25.0 kg/cm2 (356 psi, 2,452 kpa) or more

Difference between each cylinder:

5.0 kg/cm2 (71 psi, 490 kPa) or less



f.

If the cylinder compression in one or more cylinders is low, pour a small amount of engine oil into the cylinder through the glow plug hole and repeat steps (a) through (d) for the cylinder with low compression.

·

If adding oil helps the compression chances are that the piston rings and/or cylinder bore are worn or damaged.

·

If pressure stays low, a valve may be sticking or seating improperly, or there may be leakage past the gasket.



Hide 6.RECONNECT INJECTION PUMP (FUEL CUT SOLENOID) CONNECTOR