Home › Engine / Hybrid System › 1HZ STARTING › PRE-HEATING SYSTEM(for Fixed Delay Type)
RM2850E _51 Engine / Hybrid System _073156 1HZ STARTING _0355979 PRE-HEATING SYSTEM(for Fixed Delay Type) G

1HZ STARTING  PRE-HEATING SYSTEM(for Fixed Delay Type)  INSPECTION  


PROCEDURE

Hide 1.INSPECT LIGHTING TIME OF GLOW INDICATOR

a.

Turn the ignition switch ON, and measure the lighting time.

Light lighting time:

12 V type: 5.1 - 6.9 seconds

24 V type: 4.25 - 5.75 seconds



Hide 2.INSPECT PRE-HEATING TIMER

a.
A423209

Disconnect the pre-heating timer connector.

LOCATION: Under the instrument panel center.


b.

Inspect the pre-heating timer circuit.

Check the connector on the wire harness side as shown in these chart:

Tester condition Condition Specified value
G-IND - Ground Ignition switch OFF No voltage
Ignition switch ON Battery voltage
IG - Ground Ignition switch OFF No voltage
Ignition switch ON Battery voltage
EG - Ground - Continuity


c.

Reconnect the pre-heating timer connector.