04226
1.INSTALL SUCTION CONTROL VALVE ASSEMBLY
Before replacing the suction control valve assembly, be sure to clean the surrounding area.
When replacing the suction control valve assembly, make sure that your hands are clean and do not use gloves, etc.
Be careful as the installation procedure differs depending on the type of suction control valve assembly.
Be sure to prevent foreign matter or water from entering the lines.
Check that the installation part has no foreign matter attached.
Apply engine oil to a new O-ring.
Be sure to use clean engine oil.
Install the O-ring to the O-ring groove of the injection pump.
Make sure that the O-ring and O-ring groove are free of foreign matter and are not damaged.
When installing the guide pins, it is sufficient to fix them lightly in place by hand.
The guide pins are used to make sure that the suction control valve assembly remains perpendicular to the injection pump when it is inserted.
Apply engine oil to the O-ring at the end of the suction control valve assembly.
Be sure to use clean engine oil.
While holding the suction control valve assembly in place, remove the guide pins, temporarily install 2 new bolts and uniformly tighten them by hand.
Do not use tools. Tighten the bolts by hand until the surfaces of the suction control valve assembly and injection pump contact each other.
Using a 5 mm hexagon wrench, uniformly tighten the 2 bolts.
9.0 N*m (92 kgf*cm, 80 in.*lbf)
Connect the connector to the suction control valve assembly.
Make sure that there is not excessive slack or tension in the wire harness of the suction control valve assembly.
2.BLEED AIR FROM FUEL SYSTEM
3.INSPECT FOR FUEL LEAK
53712C
4.INSTALL FRONT FENDER APRON LH