1.INSPECT FOR COOLANT LEAK
The sliding surface inside the engine water pump assembly is lubricated by engine coolant. As some engine coolant is discharged during normal operation, coolant residue (solids) may be found on the bottom of the engine water pump assembly. Engine coolant may leak if foreign matter enters the engine water pump assembly, however the sealing performance will recover when the foreign matter is pushed out or breaks into fine pieces.
Before performing this inspection, check that there is no engine coolant leaking from any parts other than the engine water pump assembly. If there are leaks, inspect those areas.
Perform this inspection when the engine is cold.
Visually check the engine water pump assembly.
Check that engine coolant is not dripping from the engine water pump assembly.
If engine coolant is dripping, replace the engine water pump assembly.
16371
2.REMOVE FAN PULLEY
16100
3.INSPECT ENGINE WATER PUMP ASSEMBLY
Turn the pulley and check that the engine water pump bearing moves smoothly and quietly.
If necessary, replace the engine water pump assembly.
16371
4.INSTALL FAN PULLEY