28100
1.INSTALL STARTER ASSEMBLY
Install the starter assembly with the bolt and nut.
71 N*m (724 kgf*cm, 52 ft.*lbf)
Install the wire harness clamp bracket with the bolt.
18 N*m (178 kgf*cm, 13 ft.*lbf)
Connect the 2 wire harness clamps.
Connect the terminal 50 connector to the starter assembly.
Connect the wire harness to terminal 30 with the nut, and install the terminal cap.
21 N*m (214 kgf*cm, 15 ft.*lbf)
53712C
2.INSTALL FRONT FENDER APRON LH
51441D
3.INSTALL NO. 1 ENGINE UNDER COVER
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL