Home › Engine / Hybrid System › 14B (FUEL) › FUEL INJECTION PUMP › 2017.01–2019.08
RM2850E _51 Engine / Hybrid System _073168 14B FUEL _0356039 FUEL INJECTION PUMP A

14B FUEL  FUEL INJECTION PUMP  INJECTION PUMP INSTALLATION  


PROCEDURE

Hide 22100 1.INSTALL INJECTION PUMP

NOTICE:
w/ HAC and 15B-FT:

Do not put the injection pump at an angle more than 45° from the horizontal.


a.

Install a new O-ring to the pump.


b.

Apply a light coat of engine oil on the O-ring.


c.
A430583

Align the spline toothless portions of the injection pump and injection pump drive gear, and install the injection pump.


d.
A430584

Align the matchmark of the injection pump flange and timing gear case.


e.

Install the injection pump with the 2 nuts.

Torque:

19 N*m (190 kgf*cm, 14 ft.*lbf)



f.
A430585

Install the injection pump stay with the 4 bolts.

Torque:
12 mm head:

29 N*m (295 kgf*cm, 21 ft.*lbf)

14 mm head:

38 N*m (380 kgf*cm, 27 ft.*lbf)



g.

Connect the accelerator cable (15B-FT) or accelerator link (Others) to the injection pump.


h.

Connect the injection pump connector.


Hide 3.CONNECT HOSES

a.
A430586

w/ ACSD:

Connect the water bypass pipe to the intake manifold with the 2 bolts.


b.

w/ ACSD:

Connect the 2 water bypass hoses to the thermo wax.


c.
A430587

Connect these hoses:

i.

2 fuel return hoses


ii.

BU:

Vacuum hose (for PS idle-up)


iii.

BU:

Vacuum hose (for A/C idle-up)


iv.

15B-FT:

Boost compensator hose



Hide 5.FILL RADIATOR WITH ENGINE COOLANT (w/ ACSD)

Hide 6.FILL INJECTION PUMP WITH FUEL

a.

Operate the priming pump until you feel more resistance.


Hide 7.BLEED INJECTION NOZZLES

a.

Loosen all union nuts of the injection pipe on the nozzle side.


b.

Crank the engine to bleed air and force out the fuel from the injection pipe.


Hide 8.START ENGINE AND CHECK FOR FUEL LEAKS

Hide 10.RECHECK COOLANT LEVEL (w/ ACSD)