1.WARM UP AND STOP ENGINE
Allow the engine to warm up to normal operating temperature.
11201
2.REMOVE CYLINDER HEAD COVER
3.SET N0.1 CYLINDER TO TDC/COMPRESSION
Turn the crankshaft pulley clockwise, and align its groove with the groove of the timing gear cover.
Check that the valve rocker arm on the No. 1 cylinder are loose and valve rocker arm on the No.4 cylinder are tight.
If not, turn the crankshaft 1 revolution (360°) and align the mark as above.
4.INSPECT VALVE CLEARANCE
Check only the valves indicated in the illustration.
Using a feeler gauge, measure the clearance between the adjusting screw on the valve rocker arm and the valve bridge.
Record the out - of - specification valve clearance measurements.
0.20 mm (0.008 in.)
0.36 mm (0.014 in.)
Turn the crankshaft pulley 1 revolution (360°) and align the mark as above.
Check only the valves indicated as shown. Measure the valve clearance. (See procedure in step (a))
5.ADJUST VALVE CLEARANCE
Loosen the lock nut on the valve rocker arm, and loosen the adjusting screw.
Insert a 0.20 mm (0.008 in.) feeler gage for intake or 0.36 mm (0.014 in.) feeler gage for exhaust between the adjusting screw on the valve rocker arm and the valve bridge.
Turn the adjusting screw on the valve rocker arm until the feeler gauge slides with a very slight drag, and lock the adjusting screw with the lock nut.
Recheck the valve clearance.
11201
6.REINSTALL CYLINDER HEAD COVER