Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
43520A
1.REMOVE FRONT AXLE HUB SUB-ASSEMBLY
2.REMOVE FRONT DRUM BRAKE (for Front Drum Brake)
47704
3.REMOVE FRONT DISC BRAKE DUST COVER SUB-ASSEMBLY (for Front Disc Brake)
Remove the 2 nuts and 2 bolts.
Remove the front disc brake dust cover sub-assembly LH from the steering knuckle LH.
48520
4.DISCONNECT FRONT SHOCK ABSORBER ASSEMBLY LH
Jack up the front lower suspension arm assembly LH with a wooden block between the jack and front lower suspension arm assembly LH.
Remove the nut, spring washer, plate washer and bolt, and then disconnect the front shock absorber assembly LH.
43212
5.REMOVE STEERING KNUCKLE LH
Remove the cotter pin.
Using a 27 mm socket wrench, loosen the nut.
Do not remove the nut.
Using SST, disconnect the steering knuckle LH from the front upper suspension arm assembly LH.
| *a | Turn |
| *b | Hold |
Do not damage the dust cover.
Apply a lubricant to the threads and end of SST.
Remove the cotter pin.
Using a 30 mm socket wrench, loosen the nut.
Do not remove the nut.
Using SST, disconnect the steering knuckle LH from the front lower suspension arm assembly LH.
| *a | Turn |
| *b | Hold |
Do not damage the dust cover.
Apply a lubricant to the threads and end of SST.
Remove the 2 nuts.
Remove the steering knuckle LH.
43226
6.REMOVE STEERING KNUCKLE SPACER
Perform this procedure only when replacement of the steering knuckle spacer is necessary.
Using SST and a press, remove the steering knuckle spacer from the steering knuckle LH.
Do not drop the steering knuckle LH.