1.INSPECT SHOE LINING THICKNESS
Remove the inspection hole plugs, and check the shoe lining the thickness through the holes.
If less than minimum, replace the shoes.
4.2 mm (0.165 in.)
2.REMOVE FRONT WHEELS
3.REMOVE FRONT AXLE HUB WITH DRUM
Click hereDrivetrain>AXLE AND DIFFERENTIAL>FRONT AXLE HUB>REMOVAL
If the brake drum cannot be removed easily, perform the following steps:
Insert a screwdriver through the hole in the backing plate, and reduce the brake shoe adjustment by turning the adjusting nut.
4.REMOVE RETURN SPRING
Using SST, remove the return spring.
5.REMOVE SHOE HOLD-DOWN SPRINGS
Using SST, remove the springs, cups and pins.
6.REMOVE SHOES AND RETURN SPRING
Slide the shoes and remove together with the return spring.
7. IF NECESSARY, REMOVE WHEEL CYLINDERS
Remove the union bolt and gaskets.
Use a container to catch the brake fluid.
Using SST, disconnect the brake line from the wheel cylinders.
Remove the bolts and wheel cylinders.
8. IF NECESSARY, DISASSEMBLE WHEEL CYLINDER
Remove the following parts from the wheel cylinder.
Adjusting bolt and nut
Boot
Cup
Adjuster lock spring and screw
9. IF NECESSARY, REMOVE BACKING PLATE
Remove the brake tube clamp from the backing plate.
Remove the 2 cotter pins and the 4 nuts and remove the backing plate.