Home › Drivetrain › AXLE AND DIFFERENTIAL › STEERING KNUCKLE › 2017.01–2019.08
RM2850E _52 Drivetrain _073182 AXLE AND DIFFERENTIAL _0356116 STEERING KNUCKLE A

AXLE AND DIFFERENTIAL  STEERING KNUCKLE  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 43226 1.INSTALL STEERING KNUCKLE SPACER

HINT:

Perform this procedure only when replacement of the steering knuckle spacer is necessary.


a.
C376363E01
1.844,1.01 2.333,0.74 2.333,0.74 1.813,0.49 false 2.427,0.667 3.25,1.063 0.823,0.396 10 false SST

Using SST and a press, press in a new steering knuckle spacer to the steering knuckle LH.

SST
09308-14010  09710-30061  (09710-03620)


Hide 43212 2.INSTALL STEERING KNUCKLE LH

a.
C372098

Using a 27 mm socket wrench, install the front upper suspension arm assembly LH to the steering knuckle LH with the nut.

Torque:

165 N*m (1683 kgf*cm, 122 ft.*lbf)



b.

Install a new cotter pin.

NOTICE:

If the holes for the cotter pin are not aligned, tighten the nut an additional 30°.



c.
C372099

Using a 30 mm socket wrench, install the front lower suspension arm assembly LH to the steering knuckle LH with the nut.

Torque:

205 N*m (2090 kgf*cm, 151 ft.*lbf)



d.

Install a new cotter pin.

NOTICE:

If the holes for the cotter pin are not aligned, tighten the nut an additional 30°.



Hide 48520 3.CONNECT FRONT SHOCK ABSORBER ASSEMBLY LH

a.

Jack up the front lower suspension arm assembly LH with a wooden block between the front lower suspension arm assembly LH.


b.

Connect the front shock absorber assembly LH to the front lower suspension arm assembly LH with the bolt, plate washer, spring washer and nut.

NOTICE:

Insert the bolt from the rear of the vehicle.



c.

Tighten the nut.

Torque:

69 N*m (704 kgf*cm, 51 ft.*lbf)



Hide 47704 4.INSTALL FRONT DISC BRAKE DUST COVER SUB-ASSEMBLY LH (for Front Disc Brake)

a.
C372095E01
0.875,0.375 1.135,0.646 0.26,0.271 10 true A 0.865,1.719 1.125,1.99 0.26,0.271 10 true B

Install the front disc brake dust cover sub-assembly LH to the steering knuckle LH with the 2 bolts and 2 nuts.

i.

Tighten the bolt A.

Torque:

110 N*m (1122 kgf*cm, 81 ft.*lbf)



ii.

Tighten the nut B.

Torque:

220 N*m (2243 kgf*cm, 162 ft.*lbf)




Hide 5.INSTALL FRONT DRUM BRAKE (for Front Drum Brake)

Hide 43520A 6.INSTALL FRONT AXLE HUB SUB-ASSEMBLY