Assemble the parts in the correct direction, as shown below.
1. WHEEL CYLINDER ASSEMBLE
Apply lithium soap base glycol grease to parts, as shown.
Assemble the wheel cylinder.
Install in proper direction only.
Cup
Boot
Install the adjusting bolt and nut to the wheel cylinder.
There are 2 kinds of adjusting nuts and bolts. Make sure each location has its correct adjusting nuts and bolts.
RH Wheel (R mark)- Right-hand threads
LH Wheel (L mark) - Left- hand threads
Install the adjusting lock spring with the screw.
2.INSTALL BACKING PLATE TO STEERING KNUCKLE
Install the backing plate with the nuts, and tighten the nuts.
185 N*m (1,900 kgf*cm, 137 ft*lbf)
Install 2 new cotter pins.
3.INSTALL BLEEDER PLUG
Front-wheel cylinder union seats are flat and flare shaped, as shown.
Both union seats of front side wheel cylinder are flat.
4.INSTALL WHEEL CYLINDERS TO BACKING PLATE
Install the front side wheel cylinder with the adjuster facing downward.
Install the rear side wheel cylinder with the adjuster facing upward.
Tighten the mounting bolts of the wheel cylinders.
61 N*m (620 kgf*cm, 45 ft*lbf)
5.INSTALL BRAKE LINE TO WHEEL CYLINDER
Install the brake line in place and tighten the nuts by finger, then tighten them with SST.
15 N*m (155 kgf*cm, 11 ft*lbf)
Install the brake hose on the wheel cylinder with 2 new gaskets.
30 N*m (310 kgf*cm, 22 ft*lbf)
6.INSTALL BRAKE TUBE CLAMP TO BACKING PLATE
7.INSTALL BRAKE SHOES
Apply high temperature grease to the brake shoe contact surfaces, as shown.
Hook the return spring to the brake shoe front inner side.
Install the brake shoes, as shown in the illustration.
Install the shoe so that the letters "ANCHOR" on the shoe are directly above the anchor of the body.
Using SST, install the shoe hold-down springs, cups and pins.
Using SST, install the other side return spring.
8.CLEAN LINING AND INNER DRUM WITH SANDPAPER
9.INSTALL AXLE HUB WITH DRUM
10. FILL BRAKE RESERVOIR WITH BRAKE FLUID AND BLEED BRAKE SYSTEM
w/ Brake pedal Load Sensing Switch
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID (w/ Brake pedal Load Sensing Switch)>BLEEDING
w/o Brake pedal Load Sensing Switch
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID (w/o Brake pedal Load Sensing Switch)>BLEEDING
11. CHECK FLUID LEAKAGE
12.ADJUST BRAKE SHOE CLEARANCE
13.INSTALL WHEELS