Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB
RM2850E _52 Drivetrain _073182 AXLE AND DIFFERENTIAL _0356118 REAR AXLE HUB A

AXLE AND DIFFERENTIAL  REAR AXLE HUB  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

Replace the inner and outer races with new ones as a set only if the outer races of the bearings are removed.

Applicable Parts Outer Race Removal and Installation Procedure Reusable/Non-reusable
(Replace the inner and outer races as a set.)
Rear axle hub inner bearing Procedure performed Non-reusable
Procedure not performed Reusable
Rear axle hub outer bearing Procedure performed Non-reusable
Procedure not performed Reusable


PROCEDURE

Hide 42430 1.INSTALL AXLE HUB TO AXLE HOUSING

a.

Place the axle hub with drum to the axle housing.

NOTICE:

Be careful not to damage the ABS speed sensor rotor (w/ ABS) and oil seal.



b.

Install the outer bearing.


Hide 2.ADJUST PRELOAD

a.
C396740

Using SST, install the bearing lock nut.

SST
09513-36020  

Torque:

56 N*m (575 kgf*cm, 41 ft.*lbf)



b.

Turn the axle hub several times to settle down the bearing.


c.

Retighten the lock nut.

Torque:

56 N*m (575 kgf*cm, 41 ft.*lbf)



d.
C396741

Using SST, loosen the lock nut by 30°.

SST
09513-36020  


e.
C396742

Temporarily install the lock nut plate.

If the screw holes are not aligned, correct by tightening the nut by the smallest amount possible.


f.

Remove the lock nut plate.


g.
C396743

Using a spring tension gauge, measure the preload.

Preload (at starting):

10 - 29 N (1.0 - 3.0 kgf, 2.2 - 6.6 lbf)


If the preload is not within the specified value, repeat the above procedure.


h.
C396744

Using a dial indicator, check the axle hub axial play.

Maximum:

0.10 mm (0.0039 in.)



Hide 3.INSTALL LOCK NUT PLATE

Torque:

5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 42312 4.INSTALL REAR AXLE SHAFT