42181
1.INSTALL REAR DIFFERENTIAL CARRIER GASKET
Remove dust and oil on the connecting surfaces of the rear differential carrier assembly and the axle housing.
Install a new rear differential carrier gasket to the axle housing.
41101
2.INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY
Apply adhesive to the differential carrier installation bolt.
| *1 | Adhesive |
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
Be sure to apply enough adhesive to the threads as shown in the illustration.
Install the bolt within 20 minutes after applying adhesive.
Using a jack, install the rear differential carrier assembly to the axle housing.
Be sure to install the rear differential carrier assembly with the ring gear teeth facing the right side of the vehicle when setting on a jack.
Install the rear differential carrier assembly with the 8 bolts, 4 nuts and 4 washers.
52 N*m (530 kgf*cm, 38 ft.*lbf)
37100
3.INSTALL PROPELLER SHAFT ASSEMBLY
42312
4.INSTALL REAR AXLE SHAFT
5.ADD DIFFERENTIAL OIL
Add differential Oil.
3.8 liters (4.0 US qts, 3.3 Imp. qts)
Hypoid gear oil API GL-5 or equivalent
SAE 90
6.INSPECT DIFFERENTIAL OIL
Check that the oil surface is within 5 mm (0.197 in.) of the lowest position of the inner surface of the differential filler plug opening.
| *a | 0 to 5 mm (0 to 0.197 in.) |
Excessively large or small amounts of oil may cause trouble.
After replacing oil, drive the vehicle and check the oil level.
If necessary, fill the rear differential carrier with hypoid gear oil.
Install the filler plug with a new gasket.
50 N*m (510 kgf*cm, 37 ft.*lbf)
7.INSPECT FOR DIFFERENTIAL OIL LEAK