1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2.DRAIN MANUAL TRANSMISSION OIL
Remove the drain plug and gasket and then drain the manual transmission oil.
Install a new gasket and drain plug.
37 N*m (377 kgf*cm, 27 ft.*lbf)
37110B
3.REMOVE PROPELLER SHAFT GUARD (w/ Propeller Shaft Guard)
37100
4.REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
(See Pub. No. RM339E on page PR-7)
17410
5.REMOVE FRONT EXHAUST PIPE ASSEMBLY
fir N04C-UH:
Click hereEngine / Hybrid System>N04C-UH EXHAUST>EXHAUST PIPE>REMOVAL
fir N04C-VL:
Click hereEngine / Hybrid System>N04C-VL EXHAUST>EXHAUST PIPE>REMOVAL
fir N04C-VQ:
Click hereEngine / Hybrid System>N04C-VQ EXHAUST>EXHAUST PIPE>REMOVAL
46501
6.REMOVE PARKING BRAKE DRUM SUB-ASSEMBLY
for Parking Brake Drum with Inner Diameter of 160mm:
for Parking Brake Drum with Inner Diameter of 200mm:
46503C
7.REMOVE PARKING BRAKE PLATE SUB-ASSEMBLY
Remove the 4 bolts and parking brake plate sub-assembly.
Using a piece of rope, hang the parking brake plate to the vehicle.
33820B
8.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
Remove the 2 clips and 2 nuts and disconnect the 2 transmission control cables.
33827
9.REMOVE NO. 3 TRANSMISSION CONTROL CABLE BRACKET
Remove the 2 bolts and transmission control cable bracket.
10.DISCONNECT CONNECTOR
Disconnect the back-up light switch connector.
Disconnect the speed sensor connector.
Disconnect the exhaust brake neutral switch connector.
51204
11.REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY
Support the manual transmission with a transmission jack.
Remove the 12 bolts.
Remove the 4 nuts and remove the No. 3 frame crossmember.
33110
12.REMOVE MANUAL TRANSMISSION ASSEMBLY
Remove the 12 bolts and the transmission.
12325
13.REMOVE NO. 3 ENGINE MOUNTING BRACKET
Remove the 4 bolts and the No. 3 engine mounting bracket.
12321
14.REMOVE NO. 1 ENGINE MOUNTING BRACKET
Remove the 4 bolts and the No. 1 engine mounting bracket.
33107
15.REMOVE UPPER TRANSMISSION COVER SUB-ASSEMBLY
Remove the 6 bolts and the upper transmission cover.