Use the same procedure for RHD and LHD vehicles.
The procedures listed below are for RHD vehicles.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Pretensioner and Force Limiter)
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
2.REMOVE FRONT SEAT ASSEMBLY RH
46243
3.REMOVE PARKING BRAKE LEVER COVER
73233
4.REMOVE OUTER LAP BELT ANCHOR COVER
Detach the 3 guides and remove the outer lap belt anchor cover.
5.REMOVE FRONT SEAT OUTER BELT ASSEMBLY RH
Loosen the bolt and disconnect the floor anchor of the front seat outer belt assembly RH.
62515B
6.REMOVE NO. 1 SIDE TRIM BASE COVER RH
62311C
7.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH
Partially remove the front door opening trim weatherstrip RH so that the lower center pillar garnish can be removed.
62413A
8.REMOVE LOWER CENTER PILLAR GARNISH RH
73210
9.REMOVE FRONT SEAT OUTER BELT ASSEMBLY RH
Using a moulding remover D, detach the 2 claws and open the shoulder anchor cover.
Loosen the bolt and disconnect the shoulder anchor of the front seat outer belt assembly RH.
w/ Pretensioner and Force Limiter:
Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the pretensioner connector as shown in the illustration.
| *a | Protective Tape |
| *b | Locking Button |
Tape the screwdriver tip before use.
Remove the bolt.
Detach the 2 guides and remove the front seat outer belt assembly RH.