1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
for 2 Connectors Type:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for 2 Connectors Type)>PRECAUTION
for 3 Connectors Type:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for 3 Connectors Type)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
58841A
3.REMOVE SHIFTING HOLE COVER (for Automatic Transmission)
33504F
4.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)
58534A
5.REMOVE TRANSMISSION COVER MAT (for Manual Transmission)
58286
6.REMOVE SHIFT LEVER BOOT (for Manual Transmission)
58123A
7.REMOVE SHIFT LEVER HOLE COVER (for Manual Transmission)
55433B
8.REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
55412D
9.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL
55470
10.REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY
55601C
11.REMOVE INSTRUMENT PANEL UNDER TRAY SUB-ASSEMBLY
89173
12.REMOVE FRONT AIRBAG SENSOR
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Disconnect the airbag connector.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Push down the housing lock and slide the CPA. (At this time, the connector cannot be disconnected yet.)
| *a | Housing Lock | *b | CPA |
| *c | CPA Upper Part | - | - |
Push the housing lock again and disconnect the connector.
Do not push down the upper part of the CPA shown in the illustration when disconnecting the airbag connector.
After disconnecting the connector, check that the position of the housing lock is correct as shown in the illustration.
| *a | Incorrect | *b | Correct |
Remove the bolt.
Loosen the bolt while holding the front airbag sensor because the front airbag sensor guide is easily damaged.
Detach the guide and remove the front airbag sensor.