Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION (w/ Airbag System)
Be sure to read Precaution thoroughly before servicing.
for 2 Connectors Type:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for 2 Connectors Type)>PRECAUTION
for 3 Connectors Type:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for 3 Connectors Type)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Airbag System)
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
45130
4.REMOVE HORN BUTTON ASSEMBLY (w/ Airbag System)
45100
5.REMOVE STEERING WHEEL ASSEMBLY
45287
6.REMOVE LOWER STEERING COLUMN COVER
45286B
7.REMOVE UPPER STEERING COLUMN COVER
84306
8.REMOVE SPIRAL CABLE SUB-ASSEMBLY (w/ Airbag System)
84650
9.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY
84140
10.REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY
Disconnect the connector.
While loosening the band clamp as shown in the illustration and detach the claw.
Pull the headlight dimmer switch assembly to remove it.NOTICE:
If the claw is pressed forcefully, it will break.