Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
81980
1.INSTALL TURN SIGNAL FLASHER ASSEMBLY
Attach the clamp to install the turn signal flasher assembly.
Connect the connector.
2.INSTALL INSTRUMENT PANEL ASSEMBLY
3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
4. PERFORM DIAGNOSTIC SYSTEM CHECK
5. CHECK SRS WARNING LIGHT
for 2 Connectors Type:
for 3 Connectors Type: