If brake fluid leaks onto any painted surface, immediately wash it off.
for Automatic Transmission:
Move the shift lever to P and apply the parking brake before replace the brake fluid.
for Manual Transmission:
Move the shift lever to neutral and apply the parking brake before replace the brake fluid.
1.REPLACE BRAKE FLUID
Remove the reservoir tank door (Click hereVehicle Interior>INTERIOR PANEL>INSTRUMENT PANEL SAFETY PAD>REMOVAL).
Remove the brake master cylinder reservoir filler cap assembly.
Fill the reservoir with brake fluid.
SAE J1703 or FMVSS No. 116 DOT3
SAE J1704 or FMVSS No. 116 DOT4
Make sure that there is sufficient brake fluid in the reservoir.
Do not remove the filter from the brake master cylinder reservoir and be sure to fill the brake master cylinder reservoir with new brake fluid to avoid any potential contamination of the brake system. Contamination, for example by dirt particles or mineral oil, could lead to functional brake problems.
Remove the bleeder plug cap.
Connect a vinyl tube to the bleeder plug.
Loosen the bleeder plug.
Repeatedly depress the brake pedal until new brake fluid comes out.
Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while replacing the brake fluid.
Tighten the bleeder plug while depressing the brake pedal.
11 N*m (110 kgf*cm, 8 ft.*lbf)
11 N*m (112 kgf*cm, 8 ft.*lbf)
Install the bleeder plug cap.
Repeat the above procedure for each wheel to replace the brake fluid.
Inspect for brake fluid leaks.
Inspect the brake fluid level in the reservoir (Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID (w/ Brake pedal Load Sensing Switch)>ON-VEHICLE INSPECTION).
Install the brake master cylinder reservoir filler cap assembly.
Install the reservoir tank door (Click hereVehicle Interior>INTERIOR PANEL>INSTRUMENT PANEL SAFETY PAD>INSTALLATION).