1.INSTALL LOAD SENSING W/SPRING VALVE ASSEMBLY
Install the load sensing with spring valve assembly with the 4 bolts.
26 N*m (260 kgf*cm, 19 ft.*lbf)
Using a union nut wrench, install the 3 brake tubes to the load sensing with spring valve assembly.
15.2 N*m (155 kgf*cm, 11 ft.*lbf)
| *a | Torque Wrench Fulcrum Length |
| *b | Union Nut Wrench |
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When using a union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 162 mm (6.3779 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)
Install the load sensing spring bracket with the 2 bolts.
19 N*m (194 kgf*cm, 14 ft.*lbf)
2.ADD BRAKE FLUID
3.BLEED BRAKE LINE
4. CHECK REAR WHEEL CYLINDER FLUID PRESSURE
5.INSPECT BRAKE FLUID LEVEL IN RESERVOIR
6. CHECK BRAKE FLUID LEAKAGE