Home › Brake › BRAKE (REAR) › REAR BRAKE
RM2850E _54 Brake _073228 BRAKE (REAR) _0356451 REAR BRAKE A

BRAKE (REAR)  REAR BRAKE  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:

Replace the inner and outer races with new ones as a set only if the outer races of the bearings are removed.

Applicable Parts Outer Race Removal and Installation Procedure Reusable/Non-reusable
(Replace the inner and outer races as a set.)
Rear axle hub inner bearing Procedure performed Non-reusable
Procedure not performed Reusable
Rear axle hub outer bearing Procedure performed Non-reusable
Procedure not performed Reusable


PROCEDURE

Hide 1.INSPECT SHOE LINING THICKNESS

a.
C397390

Remove the inspection hole plugs, and check the shoe lining the thickness through the hole.

If less than minimum, replace the shoes.

Minimum thickness:

4.2 mm (0.165 in.)



Hide 3.REMOVE REAR WHEEL

Hide 4.REMOVE BEARING LOCK NUT

Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR AXLE HUB>REMOVAL

HINT:

Use the same procedure for the RH and LH sides.


Hide 5.REMOVE AXLE HUB WITH DRUM

HINT:

If the brake drum cannot be removed easily, perform the following steps:


a.
C397391

w/o Auto Adjuster

i.

Insert a screwdriver through the hole in the backing plate, and reduce the brake shoe adjustment by turning the adjusting nut.



b.
C397392

w/ Auto Adjuster

i.

Insert a screwdriver through the hole in the backing plate, and hold the adjust lever away from the adjuster.


ii.

Using another screwdriver, reduce the brake shoe adjustment by turning the adjusting nut.



Hide 6.REMOVE OUTER SIDE RETURN SPRING

C396448

Using SST, remove the outer side return spring.

SST 09703-30010

Hide 7.REMOVE SHOE HOLD-DOWN SPRINGS

C396449

Using SST, remove the hold-down springs, cups and pins.

SST 09718-00010

Hide 8.REMOVE BRAKE SHOES AND INNER SIDE RETURN SPRING

C396450

Slide the shoes and remove them together with the inner side return spring.

Hide 9. IF NECESSARY, REMOVE WHEEL CYLINDERS

a.
C397393

Remove the brake tube clamp.


b.

Using SST, disconnect the brake line from the wheel cylinders.

SST
09751-36011  

HINT:

Use a container to catch the brake fluid.



c.
C397394

Remove the bolts and wheel cylinders.


Hide 10. IF NECESSARY, DISASSEMBLE WHEEL CYLINDER

Remove the following parts from the wheel cylinder.

C397395

w/o Auto Adjuster
·

Adjusting bolt and nut

·

2 boots

·

Piston

·

2 cups


C397396

w/ Auto Adjuster
·

Adjust lever support spring

·

Adjusting bolt and nut

·

Dust seal

·

Seat

·

Wheel cylinder piston subassembly and automatic adjust lever with spring

·

2 boots

·

Piston

·

2 cups