Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM
RM2850E _54 Brake _073264 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0356689 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1433  Steering Angle Sensor Internal Circuit  


DESCRIPTION

The skid control ECU (brake actuator assembly) outputs this DTC when it receives an internal malfunction signal from the steering angle sensor.

DTC No. DTC Detection Condition Trouble Area
C1433 With the +BS terminal voltage 9.5 to 17.4 V, the skid control ECU receives an error signal from the steering angle sensor. Steering angle sensor (Spiral with sensor cable sub-assembly)

CAUTION / NOTICE / HINT

HINT:
·

When U0073, U0124 and/or U0126 is output together with C1433, inspect and repair the trouble areas indicated by U0073, U0124 and/or U0126 first (Click HereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>U0073).

·

When any of the speed sensors or the yaw rate and acceleration sensor (airbag ECU assembly) has trouble, DTCs for the steering angle sensor (spiral with sensor cable sub-assembly) may be output even when the steering angle sensor (spiral with sensor cable sub-assembly) is normal. When DTCs for the speed sensors or yaw rate and acceleration sensor (airbag ECU assembly) are output together with DTCs for the steering angle sensor (spiral with sensor cable sub-assembly), inspect and repair the speed sensor and yaw rate and acceleration sensor (airbag ECU assembly) first, and then inspect and repair the steering angle sensor (spiral with sensor cable sub-assembly).



PROCEDURE

1.REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY
a.

Replace the spiral with sensor cable sub-assembly (Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>STEERING ANGLE SENSOR (w/ Brake pedal Load Sensing Switch)>REMOVAL).

NOTICE:
·

Do not remove the steering angle sensor from the spiral with sensor cable sub-assembly.

·

When replacing the spiral with sensor cable sub-assembly, confirm that the replacement part is of the correct specification.




Result:
Proceed to
NEXT



NEXT

END