Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM(w/ Brake pedal Load Sensing Switch) › 2017.01–2019.08
RM2850E _54 Brake _073264 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0356878 ANTI-LOCK BRAKE SYSTEM(w/ Brake pedal Load Sensing Switch) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM(w/ Brake pedal Load Sensing Switch)  C1419  Acceleration Sensor Internal Circuit  C1435  Yaw Rate Sensor Internal Circuit  


DESCRIPTION

These DTCs are stored when the skid control ECU (brake actuator assembly) receives an internal malfunction signal from the yaw rate and acceleration sensor (yaw rate sensor)*1 or yaw rate and acceleration sensor (airbag ECU assembly)*2.

These DTCs are also output when calibration has not been completed.

*1: w/o Airbag System

*2: w/ Airbag System


DTC No. DTC Detection Condition Trouble Area
C1419 A data malfunction signal is received from the acceleration sensor.
·

Acceleration sensor (Yaw rate sensor)*1

·

Acceleration sensor (Airbag ECU assembly)*2


C1435 A data malfunction signal is received from the yaw rate sensor.
·

Yaw rate sensor*1

·

Yaw rate sensor (Airbag ECU assembly)*2



*1: w/o Airbag System

*2: w/ Airbag System


CAUTION / NOTICE / HINT

NOTICE:

When replacing the yaw rate and acceleration sensor (yaw rate sensor)*1 or yaw rate and acceleration sensor (airbag ECU assembly)*2, perform zero point calibration and store system information (Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM(w/ Brake pedal Load Sensing Switch)>CALIBRATION).

*1: w/o Airbag System

*2: w/ Airbag System



HINT:

When U0124 and/or U0126 is output together with C1419 and/or C1435, inspect and repair the trouble areas indicated by U0124 and/or U0126 first (Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM(w/ Brake pedal Load Sensing Switch)>U0073).


PROCEDURE

1.REPLACE YAW RATE SENSOR OR AIRBAG ECU ASSEMBLY
a.

Replace the yaw rate and acceleration sensor (yaw rate sensor)*1 or yaw rate and acceleration sensor (airbag ECU assembly)*2 (*1: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>YAW RATE AND ACCELERATION SENSOR (w/ Brake pedal Load Sensing Switch)>REMOVAL, *2: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG ECU>REMOVAL).

*1: w/o Airbag System

*2: w/ Airbag System


NOTICE:

Check the yaw rate and acceleration sensor signal after replacement (Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM(w/ Brake pedal Load Sensing Switch)>TEST MODE PROCEDURE).



Result:
Proceed to
NEXT



NEXT

END