Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM(w/ Brake pedal Load Sensing Switch) › 2017.01–2019.08
RM2850E _54 Brake _073264 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0356878 ANTI-LOCK BRAKE SYSTEM(w/ Brake pedal Load Sensing Switch) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM(w/ Brake pedal Load Sensing Switch)  C1442  Invalid Data Received from Deceleration Sensor  C1443  Invalid Data Received from Yaw Rate Sensor  


DESCRIPTION

The skid control ECU (brake actuator assembly) receives signals from the yaw rate and acceleration sensor (yaw rate sensor)*1 or yaw rate and acceleration sensor (airbag ECU assembly)*2 via CAN communication.

*1: w/o Airbag System

*2: w/ Airbag System


DTC No. DTC Detection Condition Trouble Area
C1442 When voltage at terminal +BS is 9.5 to 17.4 V, sensor invalid information received from acceleration sensor is ON continuously for 10 seconds or more.
·

Acceleration sensor (Yaw rate sensor)*1

·

Acceleration sensor (Airbag ECU assembly)*2


C1443 When voltage at terminal +BS is 9.5 to 17.4 V, sensor invalid information received from yaw rate sensor is ON continuously for 10 seconds or more.
·

Yaw rate sensor*1

·

Yaw rate sensor (Airbag ECU assembly)*2



*1: w/o Airbag System

*2: w/ Airbag System


CAUTION / NOTICE / HINT

NOTICE:

When replacing the yaw rate and acceleration sensor (yaw rate sensor)*1 or yaw rate and acceleration sensor (airbag ECU assembly)*2, perform zero point calibration and store system information (Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM(w/ Brake pedal Load Sensing Switch)>CALIBRATION).

*1: w/o Airbag System

*2: w/ Airbag System



PROCEDURE

1.CHECK DTC

b.

Turn the ignition switch off.


c.

Start the engine and idle it for 60 seconds, and then stop the engine.



Result:
Result Proceed to
DTCs C1442 and C1443 are not output A
DTCs C1442 and/or C1443 are output (w/ Airbag System) B
DTCs C1442 and/or C1443 are output (w/o Airbag System) C



A

B

C