Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections.
Check the radio automatic station search function by activating it.
Automatic station search function stops on a station.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check if any optional components that may decrease reception capacity, such as sunshade film or a telephone antenna, are not installed.
Do not remove optional components without permission of the customer.
Optional components are not installed.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check that the antenna assembly with holder is securely installed.
The antenna assembly with holder is installed properly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the ignition switch to ACC .
Turn on the radio and turn into AM mode.
Place a screwdriver, thin wire or other metal object on the antenna assembly with holder and check that noise can be heard from the speakers.
Noise Occurs.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the antenna connector from the radio receiver assembly.
Disconnect the antenna connector from the antenna assembly with holder.
Measure the resistance according to the value(s) in the table below Standard Resistance.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| RB-3 (MAIN) - A-1 | Always | Below 1 Ω |
| RB-4 - A-1a | Always | Below 1 Ω |
| RB-3 (MAIN) - Body ground | Always | 10 kΩ or higher |
| RB-4 - Body ground | Always | 10 kΩ or higher |
| *a | Front view of wire harness connector
(to Radio Receiver Assembly) |
| *b | Front view of wire harness connector
(to Antenna Assembly with Holder) |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the antenna connector from the radio receiver assembly.
Turn the ignition switch to ACC with radio receiver assembly connector connected.
Turn on the radio and turn into AM mode.
Place a screwdriver, thin wire or other metal object on the radio receiver assembly antenna jack and check that noise can be heard from the speakers.
Noise Occurs.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the antenna assembly with holder with a new or known good one and check if radio broadcasting can be received normally.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO ANTENNA>REMOVAL
Radio broadcasts can be received normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG