22030
1.INSTALL THROTTLE WITH MOTOR BODY ASSEMBLY
Install a new gasket onto the intake manifold.
Fit the gasket into the cutout of the intake manifold.
Install the throttle with motor body assembly with the 4 bolts.
10 N*m (102 kgf*cm , 7 ft.*lbf)
Connect the water by-pass hose.
Connect the No. 2 water by-pass hose.
Connect the throttle with motor body assembly connector.
17861
2.INSTALL INTAKE AIR CONNECTOR
Temporarily install the intake air connector onto the throttle with motor body assembly.
Connect the No. 2 ventilation hose and vacuum hose.
Install the intake air connector with the 2 bolts.
8.0 N*m (82 kgf*cm , 71in.*lbf)
Tighten the 2 hose clamp bolts.
5.0 N*m (51kgf*cm , 44in.*lbf) for bolt A
4.8 N*m (49kgf*cm , 42in.*lbf) for bolt B
3.ADD ENGINE COOLANT
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5.4 N*m (55kgf*cm , 48in.*lbf)
5.INSPECT FOR ENGINE COOLANT LEAK
58701A
6.INSTALL FRONT ENGINE SERVICE COVER PANEL SUB-ASSEMBLY
33506F
7.INSTALL FLOOR SHIFT CONTROL SHIFT LEVER RETAINER SUB-ASSEMBLY
58123A
8.INSTALL SHIFT AND SELECT LEVER SUPPORT WITH BOOTS
58420
9.INSTALL NO. 2 ENGINE SERVICE HOLE COVER ASSEMBLY
58521D
10.INSTALL ENGINE SERVICE HOLE COVER MAT
58734B
11.INSTALL REAR ENGINE SERVICE COVER WEATHERSTRIP
58410
12.INSTALL ENGINE SERVICE HOLE COVER