1.DISCHARGE FUEL SYSTEM PRESSURE
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
3.DRAIN ENGINE COOLANT
58410
4.REMOVE ENGINE SERVICE HOLE MAIN COVER
58734B
5.REMOVE REAR ENGINE SERVICE COVER WEATHERSTRIP
58521D
6.REMOVE ENGINE SERVICE HOLE COVER MAT
58420
7.REMOVE NO. 2 ENGINE SERVICE HOLE COVER ASSEMBLY
58123A
8.REMOVE SHIFT AND SELECT LEVER SUPPORT WITH BOOTS
33506F
9.REMOVE FLOOR SHIFT CONTROL SHIFT LEVER RETAINER SUB-ASSEMBLY
58701A
10.REMOVE FRONT ENGINE SERVICE COVER PANEL SUB-ASSEMBLY
17861
11.REMOVE INTAKE AIR CONNECTOR
22030
12.REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY
23271F
13.DISCONNECT FUEL HOSE
Pull the fuel hose connector cover up to release the lock.
Disengage the fuel connector to disconnect the fuel hose.
23807
14.REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY
Be careful not to drop the injectors when removing the delivery pipe.
Loosen the clip and disconnect the fuel hose.
Disconnect the 4 injector connectors.
Separate the wire harness clamp.
Remove the 2 bolts, O-ring and fuel pressure pulsation damper assembly.
Remove the 2 bolts and fuel delivery pipe sub-assembly with the 4 injectors.
Remove the 2 spacers.
Using a screwdriver, pry out the 4 spacers from the cylinder head.
Remove the 4 O-rings from the 4 spacers.
23250
15.REMOVE FUEL INJECTOR ASSEMBLY
Pull out the 4 injectors from the delivery pipe.
Remove the O-rings from the injectors.
Remove the 4 injector vibration insulators from the 4 fuel injector assemblies.