1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
16701
2.REMOVE FAN SHROUD SUB-ASSEMBLY
17113D
3.REMOVE NO. 1 INTAKE PIPE
27020
4.REMOVE GENERATOR ASSEMBLY
Disconnect the 4 wire harness clamps.
Remove the 2 bolts and disconnect the 2 wire harnesses from the generator bracket.
Remove the terminal cap and the nut, and then disconnect the wire harness from the terminal B.
Disconnect the connector from the generator assembly.
Remove the 3 bolts and the generator bracket.
Remove the bolt and the generator assembly.