Home › Drivetrain › A861E (AUTOMATIC TRANSMISSION / TRANSAXLE) › PARK / NEUTRAL POSITION SWITCH › from 2019.08
RM2850E _52 Drivetrain _082622 A861E AUTOMATIC TRANSMISSION / TRANSAXLE _0398780 PARK / NEUTRAL POSITION SWITCH A

A861E AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  INSTALLATION  


PROCEDURE

Hide 84540 1.INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.

Install the park/neutral position switch assembly and temporarily install the 2 bolts.

HINT:

Tightening is performed when adjusting the park/neutral position switch assembly.



b.

Install the nut stopper and lock nut.

Torque:
7.0 N*m (71 kgf*cm, 62 in.*lbf)


c.

Using a screwdriver, stake the nut stopper.


Hide 84540 2.ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY

Hide 35573 3.INSTALL TRANSMISSION CONTROL SHAFT LEVER LH

a.

Install the transmission control shaft lever LH to the park/neutral position switch assembly with the double nut.

Torque:
12.5 N*m (127 kgf*cm, 9 ft.*lbf)


b.

Turn the transmission control shaft lever LH clockwise until it stops, then turn it counterclockwise 2 notches.


Hide 33820B 4.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Connect the transmission control cable assembly to the transmission control shaft lever LH with the nut.

NOTICE:
·

Move the shift lever to N, and then lightly push it toward the P side.

·

While holding the shift lever in that position, pull the shift cable toward the rear of the vehicle and secure the shift cable and transmission control shaft lever LH.