Home › Engine / Hybrid System › N04C-WA (ENGINE CONTROL) › ECD SYSTEM › from 2019.08
RM2850E _51 Engine / Hybrid System _082611 N04C-WA ENGINE CONTROL _0399963 ECD SYSTEM C

N04C-WA ENGINE CONTROL  ECD SYSTEM  P0610  Control Module Vehicle Options Error  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P0610 Control Module Vehicle Options Error Diagnosis Condition:
·

Ignition switch ON

·

Battery voltage is in the range of 10 V to 16 V


Malfunction Status:
·

Cannot receive vehicle information for at least 5 seconds


Malfunction Duration:

5 seconds or more


·

ECM

·

CAN circuit

·

Translate ECU Assembly


- DTC stored

MONITOR DESCRIPTION

Reception of vehicle information is detected.

CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
P0610 Ignition switch ON for 5 seconds or more.


CAUTION / NOTICE / HINT

NOTICE:

After replacing the ECM, the new ECM needs registration (Click hereEngine / Hybrid System>N04C-WA (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION) and initialization (Click hereEngine / Hybrid System>N04C-WA (ENGINE CONTROL)>ECD SYSTEM>INITIALIZATION).


HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


PROCEDURE

1.INSPECT CAN COMMUNICATION SYSTEM

Result:
Proceed to
NEXT



NEXT

2.CHECK DTC OUTPUT
2.CHECK DTC OUTPUT
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine / Trouble Codes.


e.

Read the DTCs.

Result:
Result Proceed to
DTC P0610 is output A
DTC P0610 and other DTCs are output B




A

3.REPLACE TRANSLATE ECU ASSEMBLY

B

4.GO TO DTC CHART
3.REPLACE TRANSLATE ECU ASSEMBLY
a.

Replace the translate ECU assembly.

Click herePower Source / Network>CAN COMMUNICATION>TRANSLATE ECU>REMOVAL


Result:
Proceed to
NEXT



NEXT

5.CHECK DTC OUTPUT
4.GO TO DTC CHART

NEXT

5.CHECK DTC OUTPUT
5.CHECK DTC OUTPUT
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS on.


c.

Clear the DTCs.

HINT:

Clear the DTCs with the engine stopped, as DTCs cannot be cleared while the engine is running.



d.

Turn the ignition switch off for 30 seconds or more.


e.

Perform the confirmation driving pattern.


f.

Turn the GTS on.


g.

Enter the following menus: Powertrain / Engine / Trouble Codes.


h.

Confirm that the DTC is not output again.


Result:
Proceed to
NEXT



NEXT

END