| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P240F | EGR Slow Response | Diagnosis Condition:
4 seconds after the read opening changes by 31% or more. Malfunction Status: A divergence of 10% or more continues between the read opening and actual opening for 200 msec or more. Malfunction Duration: 4 seconds or more |
EGR valve assembly | Class B1 | DTC stored |
EGR valve is a butterfly type.
EGR valve opening is controlled by engine speed and amount of intake air.
EGR valve opening is adjusted by ECM and CAN communication.
EGR valve will not operate when engine coolant temperature is low (30°C (86°F) or less).
ECM calculates the actual EGR rate based on information from the boost pressure sensor, engine speed sensor, intake manifold temperature sensor, and air flow meter.
ECM compares the actual EGR rate and the theoretical EGR rate stored in the ECU memory.
| DTC No. | DTC Detection Drive Pattern |
|---|---|
| P240F | After starting the engine, warm it up until the engine coolant temperature is 80°C or more. |
After replacing the ECM, the new ECM needs registration (Click hereEngine / Hybrid System>N04C-WA (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION) and initialization (Click hereEngine / Hybrid System>N04C-WA (ENGINE CONTROL)>ECD SYSTEM>INITIALIZATION).
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine / Active Test / Control the EGR Valve Position / Data List / Actual EGR Valve Position and Target EGR Valve Position.
Check each step from 90 to 0% of the time lag of the target EGR valve opening and actual EGR valve opening.
Perform the inspection while the engine is stopped to avoid engine damages.
The response delay should be less than 5 seconds.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the EGR valve for damage due to foreign substances.
Check if there is soot obstructing the exhaust gas passageway inlet or outlet.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Clear the DTCs.
Clear the DTCs with the engine stopped, as DTCs cannot be cleared while the engine is running.
Turn the ignition switch off for 30 seconds or more.
Perform the confirmation driving pattern.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Confirm that the DTC is not output again.
| Proceed to |
|---|
| NEXT |
NEXT
Remove foreign substances and clean the EGR valve assembly.
If damaged, replace the EGR valve assembly.
| Proceed to |
|---|
| NEXT |
NEXT
Replace the EGR valve assembly.
Click hereEngine / Hybrid System>N04C-WA (EMISSION CONTROL)>EGR VALVE>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT