| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P0605 | Internal Control Module Read Only Memory (ROM) Error | Diagnosis Condition:
Ignition switch ON Malfunction Status: ·
Flash ROM check sum error ·
Failure determination time 100 msec or more Malfunction Duration: 100 msec or more |
ECM | Class B1 | DTC stored |
| P0606 | Control Module Processor | Diagnosis Condition:
Ignition switch ON Malfunction Status: ·
CPU malfunction detected ·
Failure determination time 100 msec or more Malfunction Duration: 100 msec or more |
ECM | - | DTC stored |
| P0607 | Control Module Performance | Diagnosis Condition:
Ignition switch ON Malfunction Status: ·
Failure of IC for monitoring inside ECM is detected ·
Failure determination time 100 msec or more Malfunction Duration: 100 msec or more |
ECM | - | DTC stored |
| P060C | Internal Control Module Main Processor Performance | Diagnosis Condition:
Ignition switch ON Malfunction Status: When CPU in the ECM failure is continued for at least 0.1 second. Malfunction Duration: 0.1 seconds or more |
ECM | - | DTC stored |
ECM flash ROM failure is detected.
| DTC No. | DTC Detection Drive Pattern |
|---|---|
| P0605
P0606 P0607 P060C |
Ignition switch ON for 1 seconds or more. |
After replacing the ECM, the new ECM needs registration (Click hereEngine / Hybrid System>N04C-WA (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION) and initialization (Click hereEngine / Hybrid System>N04C-WA (ENGINE CONTROL)>ECD SYSTEM>INITIALIZATION).
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
|---|---|
| DTC P0605, P0606, P0607 or P060C is output | A |
| DTCs are not output | B |
A
B
Temporary operating error due to radio wave interference or noise.
Replace the ECM.
Click hereEngine / Hybrid System>N04C-WA (ENGINE CONTROL)>ECM>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Clear the DTCs.
Clear the DTCs with the engine stopped, as DTCs cannot be cleared while the engine is running.
Turn the ignition switch off for 30 seconds or more.
Perform the confirmation driving pattern.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Confirm that the DTC is not output again.
| Proceed to |
|---|
| NEXT |
NEXT