| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| U0073 | Control Module Communication Bus "A" Off | Diagnosis Condition:
·
Ignition switch ON ·
ECM power supply voltage is in the range of 10 V to 16 V Malfunction Status: Buss off condition continues for 96 ms or longer Malfunction Duration: 96 ms or more |
·
Harness or connector ·
ECM |
Class A | DTC stored |
| DTC No. | DTC Detection Drive Pattern |
|---|---|
| U1001 | Ignition switch ON for 1 second |
After replacing the ECM, the new ECM needs registration (Click hereEngine / Hybrid System>N04C-WA (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION) and initialization (Click hereEngine / Hybrid System>N04C-WA (ENGINE CONTROL)>ECD SYSTEM>INITIALIZATION).
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
According to the display on the GTS, select "Health Check".
Check for currently output system DTCs.
| Result | Proceed to |
|---|---|
| DTC U0073 is output | A |
| DTCs are not output | B |
A
B
Click hereEngine / Hybrid System>N04C-WA (ENGINE CONTROL)>ECD SYSTEM>CHECK FOR INTERMITTENT PROBLEMS