Home › Engine / Hybrid System › N04C-WA (ENGINE CONTROL) › ECD SYSTEM › from 2019.08
RM2850E _51 Engine / Hybrid System _082611 N04C-WA ENGINE CONTROL _0399963 ECD SYSTEM C

N04C-WA ENGINE CONTROL  ECD SYSTEM  P229E  NOx Sensor Circuit Bank 1 Sensor 2  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P229E NOx Sensor Circuit Bank 1 Sensor 2 Diagnosis Condition:
·

Circuit open

-

Ignition switch ON

-

Power supply voltage for nitrogen oxides sensor is in the range of 10 to 16 V.


·

Circuit short

Ignition switch ON



Malfunction Status:
·

Circuit open

Signals outside the threshold continues for more than 3 seconds.


·

Circuit short

Failure of the No. 2 nitrogen oxides sensor is received from CAN data.



Malfunction Duration:
·

Circuit open

3 seconds or more


·

Circuit short

-



No. 2 nitrogen oxides sensor Class A DTC stored

MONITOR DESCRIPTION

·

No. 2 nitrogen oxides sensor is controlled by the nitrogen oxides sensor controller.

·

The nitrogen oxides sensor controller is connected via the ECM and DCU (emission control ECU) through CAN communication, and it sends and receives data.


CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
P229E PM forced regeneration

WIRING DIAGRAM

CAUTION / NOTICE / HINT

HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


PROCEDURE

1.CHECK OTHER DTC OUTPUT
a.

Turn the ignition switch to ON and turn the ignition switch off and wait for 5 seconds or more.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus: Powertrain / Engine / Trouble Codes.


f.

Read the DTCs.

Result:
Result Proceed to
DTC U029E is not output A
DTC U029E is output B




A

2.REPLACE NO. 2 NITROGEN OXIDES SENSOR

B

2.REPLACE NO. 2 NITROGEN OXIDES SENSOR
a.

Replace the No. 2 nitrogen oxides sensor.

Click hereEngine / Hybrid System>N04C-WA (ENGINE CONTROL)>NITROGEN OXIDES SENSOR>REMOVAL


Result:
Proceed to
NEXT



NEXT

END