When replacing the ECM and/or any other components in the following chart, perform the corresponding utility items.
INJECTOR COMPENSATION CODE
Each injector has different fuel injection characteristics. In order to optimize fuel injection performance, the ECM compensates for these differences by adjusting the fuel injection duration of each injector assembly according to its compensation code. Injector compensation codes are printed on the head portion of each injector assembly.
If an incorrect injector compensation code is input into the ECM, the engine may rattle or engine idling may become rough. In addition, engine failure may occur and the life of the engine may be shortened.
| *1 | Injector assembly |
| *a | Injector Compensation Code |
When an injector assembly is replaced, the injector's compensation code must be input into the ECM (Click hereEngine / Hybrid System>N04C-WA (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION).
Although some injectors are marked with a 32-digit alphanumeric value, only the first 30-digits must to be input.
When the ECM is changed, all of the existing injector compensation codes must be input into the new ECM (Click hereEngine / Hybrid System>N04C-WA (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION).
FOR USING GTS
Observe the following items for safety reasons:
Before using the GTS, read its instruction manual.
Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.
When driving the vehicle for testing purposes using the GTS, two persons are required. One is for driving the vehicle, and the other operates the GTS.