58521D
1.REMOVE ENGINE SERVICE HOLE COVER MAT
58410
2.REMOVE ENGINE SERVICE HOLE COVER
58734B
3.REMOVE REAR ENGINE SERVICE COVER WEATHERSTRIP
58420
4.REMOVE NO. 2 ENGINE SERVICE HOLE COVER ASSEMBLY
58123A
5.REMOVE SHIFT AND SELECT LEVER SUPPORT WITH BOOTS (for Manual Transmission)
58841A
6.REMOVE SHIFTING HOLE COVER (for Automatic Transmission)
33820B
7.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
58701A
8.REMOVE FRONT ENGINE SERVICE COVER PANEL SUB-ASSEMBLY
9.DRAIN ENGINE COOLANT
10.REMOVE EXHAUST GAS TEMPERATURE SENSOR (for EGR Cooler Side)
53711C
11.REMOVE FRONT FENDER APRON RH
17113D
12.REMOVE INTAKE PIPE
Loosen the hose clamp and disconnect the No. 1 intercooler air hose.
Remove the bolt and 2 nuts.
Remove the intake pipe and gasket.
17700
13.REMOVE AIR CLEANER ASSEMBLY
17341F
14.REMOVE NO. 1 AIR HOSE
Detach the 4 wire harness clamps.
Loosen the hose clamp and disconnect the No. 3 pcv hose.
Remove the bolt.
Loosen the hose clamp and disconnect the No. 1 air hose from the turbo charger sub-assembly.
12601B
15.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
44360
16.DISCONNECT VANE PUMP OIL RESERVOIR ASSEMBLY
Disconnect the 3 bolts and vane pump oil reservoir assembly.
44379A
17.REMOVE NO. 2 OIL RESERVOIR BRACKET
Remove the 3 bolts and No. 2 oil reservoir bracket.
12203
18.REMOVE PCV PIPE SUB-ASSEMBLY
Slide the 2 clips and remove the pcv hose.
Slide the clip and disconnect the No. 2 pcv hose.
Remove the 2 bolts and pcv pipe sub-assembly.
11409
19.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE
Detach the 2 wire harness clamps.
Remove the bolt and engine oil level dipstick guide.
Remove the O-ring from the engine oil level dipstick guide.
20.REMOVE NO. 3 TURBO INSULATOR
Remove the 4 bolts and No. 3 turbo insulator.
21.REMOVE NO. 2 TURBO INSULATOR
Remove the 3 bolts and No. 2 turbo insulator.
17505H
22.REMOVE NO. 2 EXHAUST PIPE HEAT INSULATOR SUB-ASSEMBLY
Remove the 2 bolts and No. 2 exhaust pipe heat insulator sub-assembly.
25608
23.REMOVE EGR COOLER SUB-ASSEMBLY
Remove the 2 bolts and gasket.
Disconnect the water by-pass hose and reserve tank hose.
Disconnect the No. 1 water by-pass hose and No. 2 water by-pass hose.
Remove the 4 bolts, EGR cooler sub-assembly and gasket.
25611
24.REMOVE EGR PIPE CONNECTOR
Remove the 3 nuts and 3 spacers.
Remove the EGR pipe connector and gasket from the EGR cooler sub-assembly.
17505G
25.REMOVE NO. 1 EXHAUST PIPE HEAT INSULATOR SUB-ASSEMBLY
Remove the 3 bolts and No. 1 exhaust pipe heat insulator sub-assembly from the EGR cooler sub-assembly.