The skid control ECU (brake actuator assembly) outputs this DTC when it receives an internal malfunction signal from the steering angle sensor.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1433 | With the +BS terminal voltage 9.5 to 17.4 V, the skid control ECU receives an error signal from the steering angle sensor. | Steering angle sensor (Spiral with sensor cable subassembly) |
Refer to DTC C1432 (Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM(w/ Brake pedal Load Sensing Switch)>C1432).
When U0073, U0124 and/or U0126 is output together with C1433, inspect and repair the trouble areas indicated by U0073, U0124 and/or U0126 first (Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM(w/ Brake pedal Load Sensing Switch)>U0073).
When any of the speed sensors or the yaw rate and acceleration sensor (airbag ECU assembly) has trouble, DTCs for the steering angle sensor (spiral with sensor cable subassembly) may be output even when the steering angle sensor (spiral with sensor cable sub-assembly) is normal. When DTCs for the speed sensors or yaw rate and acceleration sensor (airbag ECU assembly) are output together with DTCs for the steering angle sensor (spiral with sensor cable sub-assembly), inspect and repair the speed sensor and yaw rate and acceleration sensor (airbag ECU assembly) first, and then inspect and repair the steering angle sensor (spiral with sensor cable sub-assembly).
Replace the spiral with sensor cable sub-assembly (Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>STEERING ANGLE SENSOR (w/ Brake pedal Load Sensing Switch)>REMOVAL).
Do not remove the steering angle sensor from the spiral with sensor cable subassembly.
When replacing the spiral with sensor cable sub-assembly, confirm that the replacement part is of the correct specification.
| Proceed to |
|---|
| NEXT |
NEXT