1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
53712C
2.REMOVE FRONT FENDER APRON LH
3.DISCHARGE FUEL
25608
4.REMOVE EGR COOLER SUB-ASSEMBLY
11202D
5.REMOVE NO. 2 CYLINDER HEAD COVER SUB-ASSEMBLY
6.SET NO. 1 CYLINDER TO TDC/COMPRESSION
17113
7.REMOVE INTAKE PIPE
58396E
8.REMOVE WIRE HARNESS CLAMP BRACKET
Disconnect the 2 clamps.
Remove the bolt and disconnect the ground wire and engine wire.
Remove the 2 bolts and 2 wire harness clamp brackets.
Remove the nut and disconnect the engine wire.
Remove the 2 bolts and wire harness clamp bracket.
23802E
9.REMOVE FUEL PIPE SUB-ASSEMBLY
Remove the 2 nuts and 2 fuel pipe clamps.
Remove the bolt and disconnect the fuel filter to injection pump fuel pipe.
Disconnect the 2 fuel tubes.
Remove the 7 union bolts and fuel pipe sub-assembly.
Remove the 8 gaskets from the fuel pipe sub-assembly.
23812D
10.REMOVE NO. 2 FUEL PIPE
Remove the 2 nuts and 2 fuel pipe clamps.
Using a 17 mm union nut wrench, loosen the 2 union nuts.
Remove the No. 2 fuel pipe.
Be sure to prevent foreign matter or water from entering the lines.
22100
11.REMOVE SUPPLY PUMP ASSEMBLY
Disconnect the 2 connectors.
|
Bolt |
|
Nut |
Remove the nut, 2 bolts and injection pump stay.
Remove the 4 bolts and supply pump assembly.
Remove the O-ring from the timer cover.
13613
12.REMOVE INJECTION PUMP DRIVE GEAR
Clamp the injection pump assembly in a vise.
Remove the 2 bolts and timer cover.
Remove the O-ring from the timer cover.
Remove the nut, injection pump drive gear and crankshaft angle sensor plate.