Home › Engine / Hybrid System › N04C-WA (CHARGING) › GENERATOR › from 2019.08
RM2850E _51 Engine / Hybrid System _082620 N04C-WA CHARGING _0402275 GENERATOR A

N04C-WA CHARGING  GENERATOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 58521D 3.REMOVE ENGINE SERVICE HOLE COVER MAT

Hide 58410 4.REMOVE ENGINE SERVICE HOLE COVER

Hide 58734B 5.REMOVE REAR ENGINE SERVICE COVER WEATHERSTRIP

Hide 58420 6.REMOVE NO. 2 ENGINE SERVICE HOLE COVER ASSEMBLY

Hide 58123A 7.REMOVE SHIFT AND SELECT LEVER SUPPORT WITH BOOTS (for Manual Transmission)

Hide 58841A 8.REMOVE SHIFTING HOLE COVER (for Automatic Transmission)

Hide 33820B 9.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

Hide 58701A 10.REMOVE FRONT ENGINE SERVICE COVER PANEL SUB-ASSEMBLY

Hide 88310A 11.REMOVE NO. 1 V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT

Hide 16361A 12.REMOVE FAN AND GENERATOR V BELT

Hide 27020 16.REMOVE GENERATOR ASSEMBLY

a.
A398665E01
0.375,1.583 0.531,1.76 0.156,0.177 10 true *a 0.698,0.219 0.854,0.396 0.156,0.177 10 true *b 1.135,1.146 1.292,1.323 0.156,0.177 10 true *b 1.479,1.323 1.635,1.5 0.156,0.177 10 true *b 2.781,1.188 2.938,1.365 0.156,0.177 10 true *b

Remove the terminal cap.


b.

Detach the clamps.

Text in Illustration
*a Terminal Cap
*b Clamp


c.
A398666E02
0.5,1.104 0.667,1.281 0.167,0.177 10 true *b 1.26,0.385 1.427,0.563 0.167,0.177 10 true *c 1.177,1.063 1.344,1.24 0.167,0.177 10 true *c 1.677,1.885 1.844,2.063 0.167,0.177 10 true *a

Remove the nut and disconnect the terminal B.


d.

Disconnect the connector.


e.

Remove the 2 bolts and disconnect the wire harnesses from the generator bracket.

Text in Illustration
*a Nut
*b Connector
*c Bolt


f.
A398667E02
1.958,0.313 1.729,0.646 true 1.896,0.146 2.083,0.333 0.188,0.188 10 true *1

Remove the 3 bolts and the generator bracket.

Text in Illustration
*1 Generator Bracket


g.

Remove the bolt and the generator assembly.